SUB-TRANSMISSION/GEARSHIFT LINKAGE
Turn the ignition Operate the selector lever several times and shift
switch ON and the sub-transmission into neutral.
check that the neu-
tral indicator comes
on at this time.
LEVER
Make sure that the selector arm A stops at the cen-
ter (neutral) position when setting the guide rod of
the lever into the center (neutral) groove in the
selector gate.
Turn one of the lock nuts until it touches the cable
holder while holding the cable. Then, turn the other
nut in the same manner.
Be sure the nuts are seated on the cable holder and
tighten them together to secure the cable.
TORQUE: 26 N m (2.7 kgf m, 20 Ibf-ft)
Check that the selector lever operates properly.
Install the following:
-
left engine side cover (page 3-17)
-
head guard plate and fuel tank (page 6-39).
12-16