Honda TRX680FA Service Manual page 404

REAR WHEEL/SUSPENSION
Install a new stopper ring into the inner groove in
the pivot securely.
Carefully press in a new bearing until it contacts the
stopper ring (the depth from the outer surface is
12.8 mm), using the same tool.
Install a new stopper ring.
Pack each pivot (between bearing and dust seals)
with 3 g of grease.
Apply grease to the new dust seal lips and install
them until they are flush with the outer surface.
Install the pivot collars.
SHOCK ABSORBER INSTALLATION
Install new dust seals into the pivots with the lip
side facing out until they are seated.
Apply molybdenum disulfide paste to the pivot
bushings and dust seal lips.
Install the seal caps and pivot collar.
COLLAR
CAPS
Install the shock absorber into the frame with the
mounting bolt. Install a new nut.
Connect the shock absorber to the knuckle and
upper arm (page 16-16).
Install the seat (page 3-4).
16-14