Gear Position Switch - Honda TRX680FA Service Manual

Hide thumbs Also See for TRX680FA:

Table of Contents

DRIVETRAIN SYSTEM

GEAR POSITION SWITCH

Turn the ignition switch OFF.

Disconnect the PCM 33P (Black) connector (page 21-

Check for continuity between each gear position

switch wire terminal of the PCM connector and

There should be continuity only at the terminals that

correspond to the gearshift lever positions shown

below, and there should be no continuity at the

other terminals.

You must test each of the three wires in each gear-

shift lever position. Therefore, you need to make 9

tests, between each gear position switch wire termi-

nal and ground.

If the test result is abnormal, disconnect the gear

position switch 3P (Natural) connector.

Perform the continuity test at the 3P (Natural) con-

nector in the same manner (page 14-44).

If the test result at the PCM is abnormal and the

one at the 3P connector is normal, check for open

or short circuit, or loose or poor connector con-

If the both test results are abnormal, replace the

gear position switch.

Remove the following:

seat (page 3-4)

right side cover (page 3-5)

left fuel tank side cover (page 3-7)

Disconnect the gear position switch 3P (Natural)

Release the gear position switch wire from the

PCM 33P (BLACK) CONNECTOR (Wire side

of female terminal)

3P(NATURAL CONNECTOR

Chapters

Table of Contents

Trx680fga 2006 trx680fa 2006 trx680fga