Honda TRX680FA Service Manual page 265

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Apply engine oil to the bearings, gear teeth and slid-
ing areas.
Assemble the countershaft.
WASHER
GEAR SHIFTER
WASHER
OUTPUT DRIVE GEAR
LOCK WASHER
LOCK WASHER
REVERSE GEAR
BEARING (20x24x17)
BEARING (20x24x12)
BEARING (20x24x17)
: Bearings, Gear teeth and
Sliding areas
The output shaft Install the countershaft assembly by engaging the
may be installed splines.
before installing the
countershaft (page
12-13).
Apply engine oil to the fork shaft outer surface.
Before installation, Install the shift fork into the gear shifter groove and
be sure that the drum guide groove.
switch pin groove in
the shift drum is
lengthwise as
shown above.
Insert the fork shaft through the fork and install it
into the crankcase.
Apply engine oil to the gear teeth and set the output
driven gear into the crankcase.
Insert the output shaft through the driven gear and
install it into the crankcase.
Install the washer.
COUNTERSHAFT
FORK SHAFT
OUTPUT SHAFT
12-13