Drive Mode Select Switch - Honda TRX680FA Service Manual

DRIVETRAIN SYSTEM
If the test result at the PCM is abnormal and the
one at the 10P (Green) connector is normal,
check for open or short circuit, or loose or poor
connector contact.
If the both test results are abnormal, replace the
handlebar switch (gearshift switch).
DRIVE MODE SELECT SWITCH
INSPECTION
Turn the ignition switch OFF.
Disconnect the PCM 33P (Black) connector (page 21-
6).
NOTE:
• When reconnecting the PCM 33P connector,
check that there is no dirt and oil in the connec-
tor.
Check for continuity between the PCM connector
terminals in each switch position.
TOOL:
Test probe 07ZAJ-RDJA110
Continuity should exist between the color coded
wires as follows:
If the test result is abnormal, remove the right inner
fender (page 3-9).
Disconnect the drive mode select switch 3P (Black)
connector.
Perform the continuity test at the 3P (Black) connec-
tor in the same manner (page 14-46).
If the test result at the PCM is abnormal and the
one at the 3P (Black) connector is normal, check
for open or short circuit, or loose or poor connec-
tor contact.
If the both test results are abnormal, replace the
drive mode select switch.
PCM 33P (BLACK) CONNECTOR
(Wire side of female terminal)
Green Black/blue
A18
PCM 5P (BLACK) CONNECTOR
(Wire side of female terminal)
Color
Position \
ESP
D
Blue/
orange
o
Black/
green
Green
• o
3P BLACK CONNECTOR
14-46