Honda TRX680FA Service Manual page 198

ENGINE REMOVAL/INSTALLATION
Be sure the univer-
sal joint is not dis-
engaged.
Set the right lower mounting portion of the engine
between the hanger stays on the frame.
Install the mounting rubbers onto the right lower
hanger bushing with the large I.D. side facing in.
Install the spacer and the hanger bolt (from the front
side) while aligning the bolt holes carefully.
Loosely install the hanger nut.
Install the mounting rubbers onto the left lower
hanger bushing in the same manner as above.
Install the hanger bracket and bolts, and the hanger
bolt (from the front side) while aligning the bolt
holes carefully.
Loosely install the hanger nut.
Install the mounting rubbers onto the upper hanger
bushing in the same manner as above. Install the
upper engine hanger bracket and the three bolts.
After installing all the mounting fasteners and seat
them, tighten the fasteners in order as follows:
- left and right lower engine hanger nuts
TORQUE: 54 N m (5.5 kgf-m, 40 Ibfft)
- left lower engine hanger bracket bolts
- upper engine hanger bracket bolts
TORQUE: 32 N m (3.2 kgf m, 24 Ibfft)
- upper engine hanger bolt
TORQUE: 54 N m (5.5 kgf-m, 40 Ibfft)
Install a new stopper ring into the groove on the
propeller shaft end.
Apply 5 - 8 g of molybdenum disulfide grease to the
pinion joint splines of the differential.
Place the boot band over the propeller shaft.
Install the propeller shaft into the pinion joint, align-
ing the joint and shaft splines until the stopper ring
seats in the groove.
Make sure the stopper ring is seated properly by
pulling the propeller shaft lightly.
Install the boot over the pinion joint securely and
the boot band into the boot groove.
8-9