Honda TRX680FA Service Manual page 534

ELECTRIC STARTER
Install the starter motor into the rear crankcase
cover and onto the crankcase.
Install the hose guide and mounting bolts, then
tighten the bolts securely.
Route the ground cable and tighten the bolt.
Install the starter motor cable and terminal nut, and
tighten the nut.
Install the rubber cap over the cable terminal.
Install the right engine side cover and tighten the
three bolts securely.
RIGHT ENGINE SIDE COVER
Connect the battery negative (-) cable (page 20-6).
Install the following:
- right center mud guard lid (page 3-7)
- right side cover (page 3-5)
STARTER RELAY SWITCH
OPERATION INSPECTION
Remove the battery cover (page 20-6).
Shift the transmission into neutral.
Make sure the engine stop switch is turned "O"
Turn the ignition switch ON and push the starter
switch.
The coil is normal if the starter relay switch clicks.
If you don't hear the switch click, and inspect the
relay switch circuits (page 22-13).
STARTER RELAY SWITCH
22-12