Fuel Line Inspection - Honda TRX680FA Service Manual

FUEL SYSTEM (PGM-FI)
FUEL LINE INSPECTION
FUEL PRESSURE RELIEVING/QUICK
CONNECT FITTING REMOVAL
• Before disconnecting fuel feed hose, relieve pres-
sure from the system as following procedures.
• Do not bent or twist fuel feed hose.
1. Turn the ignition switch OFF.
Pull up the rubber boot and disconnect the fuel
pump 2P (Black) connector.
2. Start the engine, and let it idle until it stalls.
3. Turn the ignition switch OFF.
4. Disconnect the battery cable (page 20-6).
5. Check the fuel quick connect fitting for dirt, and
clean if necessary.
Place a shop towel over the quick connect fitting.
6. Hold the connector with one hand and squeeze
the retainer tabs with the other hand release
them from the locking pawls.
Pull the connector off.
• Prevent the remaining fuel in the fuel feed hose
from flowing out with a shop towel.
• Be careful not to damage the hose or other parts.
• Do not use tools.
• If the connector does not move, keep the retainer
tabs pressed down, and alternately pull and push
the connector until it releases.
7. To prevent damage and keep foreign matter out,
cover the disconnected connector and pipe end
with the plastic bags.
QUICK CONNECT FITTING
2P (BLACK) CONNECTOR
RETAINER TABS
JOINT RUBBER
CONNECTOR
LOCKING PAWLS
PLASTIC EiAGS
6-32