Honda TRX680FA Service Manual page 468

FRONT DRIVING MECHANISM
Install the bearing into the compressor until it is
flush with the end of the tool.
TOOL:
Bearing clip compressor, 25 mm 070ME-HN8A100
Place the driver, attachment and pilot on the top of
the bearing and tape the driver to the compressor.
TOOLS:
Driver 07949-3710001
Attachment, 22 x 24 mm 07746-0010800
Pilot, 15 mm 07746-0040300
Place the bearing and tool assembly into a freezer
for at least 30 minutes.
Heat the gear case to 80°C (176°F).
Remove the bearing and tool assembly from the
freezer and drive the bearing into the gear case
using the special tools.
Only strike the driver once. If you strike it more than
once, the ring may slip out of the groove. If this hap-
pens, remove the ring and bearing, and install a
new ring.
Make sure that the stopper ring is securely set in the
groove of the gear case.
COMPRESSOR NEEDLE BEARING
PILOT ^
(O'l
1 DRIVER
s
= 5 ^ COMPRESSOR
STOPPER RING
18-24