REAR DRIVING MECHANISM
FINAL DRIVE INSTALLATION
Install the final drive assembly onto the sub-frame
by inserting the mounting bolts from the left side.
Install new mounting nuts but do not tighten them
yet.
FINAL DRIVE ASSEMBLY i
Install the brake disc with the stamp facing the
engine side. Install new disc bolts and tighten them
in a crisscross pattern in several steps.
TORQUE: 20 N-m (2.0 kgf-m, 14 Ibf-ft)
Install a new seal rubber onto the seal groove in the
propeller shaft in the direction as shown.
Install the joint boot onto the boot groove and the
boot band into the band groove in the boot.
Apply molybdenum disulfide grease to the seal rub-
ber outer surface.
Apply 5 - 8 g of molybdenum disulfide grease to the
pinion joint splines.
Install the spring into the propeller shaft.
Set the propeller shaft into the pinion joint while
compressing the spring, then install the boot over
the pinion joint groove securely and secure it with
the boot band.
Be sure the propeller shaft is installed properly by
pulling on the shaft lightly.
BOLTS AND +3*
NUTS
BOLTS
BOOT
19-27