Honda Civic Service Manual page 1119

sRs
Component Replacement/lnspection After Deployment
NOTE: Before doing any SRS repairs. use the PGM
Tester SRS menu method to check for DTCS; refer to the
DTC Troubleshooting Index for the less obvious
deployed parts (seat beit tensioners, front sensors, side
airbag sensors, etc.)
After a collision where the seat belt tensioners
deployed, replace these items:
' Seat belt tensioners
. Seat belt buckle tensioners
. S R S u n i t
. Front impact sensors
After a collision where the front airbag(s) deployed.
replace these items:
. S R S u n i t
. Deployed airbag(s)
. Seat belt tensioners
. Seat belt buckle tensioners
. Front impact sensors
After a collision where the side airbag{s) deployed,
replace these items:
. S R S u n i t
. D e p l o y e d s i d e a i r b a g ( s )
. Side impact senso(s)for the side(s) that deployed
During the repair process, inspect these areas:
. lnspect allthe SRS wire harnesses. Replace, don't
repair, any damaged harnesses.
. I n s p e c t t h e c a b l e r e e l f o r h e a t d a m a g e . l f t h e r e i s a n y
damage, replace the cable reel.
Afterthe vehicle is completely repaired, turn the
ignition switch ON (ll). lf the SRS indicator comes on for
about 6 seconds and then goes off, the SRS airbag
system is OK. lf the indicator does not function properly,
use the PGM Tester SRS Menu Method to read the DTC
(see page 23-23). lf this doesn't retrieve any codes, use
the Tester's SCS menu method (see page 23-24). lf you
still cannot retrieve a code, go to SRS Indicator Circuit
Troubleshooting.
23-112
\ | J