Honda Civic Service Manual page 1093

sRs
DTC Troubleshooting (cont'd)
DTG 12-1: Open or Increased Resistance in
Front Passenger's Side Airbag Inflator
SpecialTools Required
. S R S i n f l a t o r s i m u l a t o r 0 7 S A Z - T 8 4 0 1 1 A
. SRS simulator lead E o7XAZ-S140200
1. Erase the DTC memory (see page 23-26).
2 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) , a n d c h e c k t h a t t h e
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SBS indicator stay on?
YES Go to step 3.
NO - Intermittent failu re, system is OK at this time.
Go to Troubleshooting lntermittent Failures (see
page 23-26).
3. Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
4. Disconnect the floor wire harness 2P connector (A)
from the front passenger's side airbag.
07xAz-s1A0200
5. Connect the SRS inflator simulator (2 Q connector)
a n d s i m u l a t o r l e a d E t o t h e f l o o r w i r e h a r n e s s .
23-86
I J
7 .
'1 0.
9 .
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 12-l indicated?
YES Go to step L
NO-Open or increased resistance in the front
passenger's side airbag inflator; replace the front
p a s s e n g e r ' s s i d e a i r b a g ( s e e p a g e 2 3 - 1 1 5 ) . 1
Turn the ignition switch OFF. Disconnect the
battery negative cable. and wait for 3 minutes.
Disconnect the driver's side airbag 2P connector
{see step 4 on page 23-21)and both seat belt buckle
tensioner 4P connectors (see step 6 on page 23-22).