Configuring The Local Host Ip Parameters - 3Com SuperStack II PathBuilder S330 Reference Manual

Figure 44 Manage IP Network Configuration Menu
From the Manage IP Network Configuration menu, you can configure the
following:
Local host IP parameters
Trap clients
Default gateway
The following subsections describe how to set these network communication
parameters.
Configuring the Local Host IP Parameters
For the PathBuilder S330/S310 switch to communicate on an Ethernet network,
you must assign an IP address to the local host interfaces: the standard 10BASE-T
Ethernet interface and (if you have installed the optional Ethernet 10/100
module), the PCI Ethernet interface.
For the PathBuilder S330/S310 switch to communicate on the network, you must
use the VT100 terminal to assign an IP address. After you have entered the IP
address for the PathBuilder S330/S310 on the VT100 terminal, you can continue
configuring the device on the local console, or you can use a Telnet session to
configure the device on a TCP/IP workstation.
To configure local host IP parameters:
1 From the Manage IP Network Configuration menu, select [1] Local Host IP
Configuration to open the Local Host IP Configuration menu, shown in Figure 45.
IOption [2] PCI Ethernet Port IP Configuration appears on the Local Host IP
Configuration menu only if you have installed an optional Ethernet 10/100
module.
Performing Initial System Configuration 49