Backing Up The Code Image - 3Com SuperStack II PathBuilder S330 Reference Manual

9 Back up all files by entering:
mget *
10 Exit FTP by entering:
bye
Restoring the Database
To restore the database:
You must have read/write access on the node to perform the restore operation.
1 Move to the directory you created earlier, in step 4 under "Backing up the
Database." This directory should contain only the database files.
2 FTP to the node (
FTP <node IP address>
FTP login is the node name (upper left corner of user interface)
FTP password is the node password (password used to access user interface)
3 Switch to binary mode by entering:
binary
4 Change directory to /fileDev/disk by entering:
cd /fileDev/disk
5 Restore all files by entering:
mput*
6 Exit FTP by entering:
bye
7 Telnet to the node.
8 Select [1] System Administration to open the System Administration menu.
9 Select [7] Update Flash File System.
10 Enter at the confirmation prompt to update the flash file system.
y
Wait for the
Update Completed
11 Select [8] Reset Interface Card to open the Reset Port Card screen.
12 Enter , for the MCPU.
1
13 Enter at the confirmation prompt to reset the MCPU.
y
14 Repeat steps 11-13 for each slot in the shelf.

Backing up the Code Image

To back up the code image:
1 From the DOS prompt, change to the directory in which you want to store the
backup code image file.
2 FTP to the node (
FTP <node IP address>
FTP login is the node name (upper left hand corner of user interface).
FTP password is the node password (password used to access user interface).
Viewing and Configuring System Information
).
message before continuing to Step 11.
).
65