Adding Ima Groups - 3Com SuperStack II PathBuilder S330 Reference Manual

82 C 4: C
HAPTER ONFIGURING
P B S330/S310 M
ATH UILDER
5 Select [1] UNI. The Add Group menu appears as shown in Figure 72.
Figure 72 Add Group Menu (Adding UNI Group)
6 Select [1] Set Admin. Port(s). The following prompt appears at the bottom of the
screen:
Enter Admin Port(s):
7 Enter the port numbers for the T1/E1 port you want to include in the UNI group.
8 Select [2] Set Admin. Status and enter
9 Select [3] Previous Menu.
10 If desired, repeat steps 5-8 to set up a second UNI group and put it into service.

Adding IMA Groups

1 From the Configuration Management menu, select [1] Manage Card to open the
List Card menu, shown earlier in Figure 60.
2 From the List Card menu, select [3] DS1 UNI to open the T1 (DS1) UNI or E1 UNI
Configuration menu, shown earlier in Figure 67.
3 From the T1 (DS1) UNI or E1 UNI Configuration menu, select [3] Group
Configuration to open the Group menu, shown in Figure 73.
, P , A
ODULES ORTS AND PPLICATIONS
to put the group in service.
2