Logging On To The System; Configuring An Ip Address - 3Com 3C8S5007 - SuperStack II PathBuilder S500 Switch User Manual

Logging On to
the System
Configuring an IP
Address
Table 10 LED Status at Successful Startup
LED
Load
Test
* During normal startup sequencing, the CSU/DSU LEDs periodically flash on and off. When the
startup sequencing is complete, these LEDs remain off. When you have completed configuring
the CSU/DSU interfaces and the interfaces are operational, these LEDs remain on.
When your switch starts up, it takes a few seconds to complete the
initialization process. While the switch is initializing, various messages will
appear on your terminal. The switch has finished booting when the
following message is displayed:
System Initialized and Running
To log on, follow these steps:
1 Press any key on the keyboard.
The following prompt is displayed:
NetLogin:
2 Enter:
root
Root is the default account name. The following prompt is displayed:
Password:
3 Press the Return key.
Pressing the Return key enters a null string, which is the default local
password. The Network Manager prompt is displayed:
Enterprise OS #
Before you can access the PathBuilder switch over one of the 10/100
Ethernet interfaces, you must assign an IP address and an IP route entry.
1 To assign an IP address, use:
SETDefault -IP !<portnumber> NETaddr = <IPaddress> <subnet mask>
For example, to set the IP address to 555.666.777.888 and the subnet
mask to 255.255.253.0 on LAN port 1, enter:
SETDefault -IP !1 NETaddr = 555.666.777.888 255.255.252.0

Logging On to the System

Status
Off
Off
39