Configuring The Local Host Ip Address - 3Com SuperStack II PathBuilder S330 Reference Manual

Performing Initial System Configuration 65
Figure 35 Manage IP Network Configuration Menu
Configuring the Local Host IP Address
In order for the PathBuilder S330/S310 to communicate on the network, you must
use the VT100 terminal to assign an IP address to the device. Once you have
entered the IP address for the PathBuilder S330/S310 on the VT100 terminal, you
can continue configuring the device on the local console, or you can use a Telnet
session to configure the device on a TCP/IP workstation.
To enter an IP address for the PathBuilder S330/S310, follow these steps:
1 From the Manage IP Network Configuration menu, select [1] Local Host IP
Configuration to display the Local Host IP Configuration menu, shown in
Figure 36.
When you apply a change to this menu, you might get logged out if you are using
a Telnet session. The default VT100 configuration is Baud rate: 9600, Parity; none,
Data Bits:8, StopBits:1.
Figure 36 Local Host IP Configuration Menu