3Com SuperStack II PathBuilder S330 Reference Manual page 153

Figure 128 Side A Completed for Video VIrtual Circuit Template
5 Select the slot number corresponding to the module by which you are connected
to the network for side B of the circuit template.
6 Repeat steps 3 and 4 for side B of the circuit template. After you enter the last
parameter for side B, the following prompt appears at the bottom of the screen:
Is the above information correct (y/n)?
7 Enter to confirm your configuration. The following message appears at the
y
bottom of the screen. Press any key to return to the Virtual Circuit menu.
VC has been added.
Press any key to continue.
Figure 129 shows a completed video virtual circuit template. When the phone
number 555-2345 is dialed, the circuit that this template defines will be activated.
Figure 129 Completed RS-366 (video) Virtual Circuit Template
Configuring Virtual Circuits 139