3Com SuperStack II PathBuilder S330 Reference Manual page 112

98 C 4: C
HAPTER ONFIGURING
P B S330/S310 M
ATH UILDER ODULES
To configure the SIM Local Management Interface (LMI):
LMI configuration applies only to Frame Relay ports. The LMI Configuration menu
is not available if the SIM port is configured as a DXI or HDLC port.
1 From the Configuration Management menu, select [1] Manage Card to open the
List Card menu, shown earlier in Figure 60.
2 From the List Card menu, select [5] SIM to open the SIM Configuration Port/Card
Selection menu, shown earlier in Figure 85.
3 Select [1] Port 1 to open the SIM Port Configuration Port/LMI selection menu,
shown earlier in Figure 86.
4 Select [2] LMI Configuration to open the SIM LMI Configuration menu, shown in
Figure 88. This menu displays the LMI configuration and provides options that
allow you to change certain parameters.
Figure 88 SIM LMI Configuration Menu
5 Change the following parameters as desired:
Protocol — The protocol specified for the Status Enquiry procedure: none,
q.933a, or t1.617d.
Procedure — Specifies whether the PathBuilder S330/S310 switch will be
designated as the user side, the network side, or bidirectional in the periodic
polling performed between Frame Relay devices.
User LIV Polling Timer (T391) — The time interval (in seconds) at which Status
Enquiry occurs for link integrity verification (LIV) polling: 5..180. This parameter
applies only when the PathBuilder S330/S310 switch is designated as the user side
unit.
Set the User LIV Polling Timer at a higher value than the Network PV Timer
parameter on the network side unit.
User FS Polling Counter (N391) — The time interval (in seconds) at which Status
Enquiry occurs for full status (FS) polling: 1..255.
, P , A
ORTS AND PPLICATIONS