Table of Contents
Advertisement
Installing the Optional Modules in the Unit
To install an optional module in the unit:
1 Turn off the power and unplug the unit.
2 Open the unit.
a Remove the eight screws (three on each side and two in the rear), as shown in
Figure 11.
Figure 11 Removing the Eight Screws from the PathBuilder S330/S310 Unit
b Push the cover back (arrow 1) and lift it up from the rear (arrow 2), as shown in
Figure 12.
Figure 12 Removing the PathBuilder S330/S310 Cover
Installation Procedures
2
1
19
Advertisement
Table of Contents
Need help?
Do you have a question about the SuperStack II PathBuilder S330 and is the answer not in the manual?
Questions and answers