3Com SuperStack II PathBuilder S330 Reference Manual page 65

3 Enter the following information (by selecting the appropriate options and
responding to the prompts that appear at the bottom of the screen) to set local
host interface parameters:
IP Address — Provided by the network administrator. This is the IP address of the
PathBuilder S330/S310 management CPU.
You should consult the network administrator to obtain an IP address for the
PathBuilder S330/S310 switch which will allow its 10BaseT Management port to
co-exist with hosts on its local LAN.
Subnet Mask — Provided by the network administrator.
The IP addresses for the 10BASE-T Ethernet interface and the 10/100BASE-T
Ethernet interface should not be on the same subnet.
Community Name — Enter
SET operation.)
Figure 47 shows a sample PathBuilder S330/S310 IP host setup.
Figure 47 Sample PathBuilder S330/S310 IP Host Setup
PathBuilder
S330/S310
192.73.30.99
192.73.30.100
4 Return to the Local Host IP Configuration menu.
5 Select [2] Apply IP Configuration Changes ([3] Apply IP Configuration Changes if
you have installed the Ethernet 10/100 module) to activate the IP address.
The IP settings do not take effect until you apply your changes by selecting
[2] Apply IP Configuration Changes ([3] Apply IP Configuration Changes if you
have installed the Ethernet 10/100 module) from the Local Host IP Configuration
menu (step 5 above).
When you apply a change from the Local Host IP Configuration menu, you might
get logged out if you are using a Telnet session. The default VT100 configuration
is Baud rate: 9600, Parity; none, Data Bits:8, StopBits:1.
Performing Initial System Configuration
(The community name applies to the SNMP
private
3Com
Community
51