3Com SuperStack II PathBuilder S330 Reference Manual page 156

142 C 4: C
HAPTER ONFIGURING
P B S330/S310 M
ATH UILDER ODULES
Figure 132 VCM VCC Add Virtual Circuit Screen with Side A Completed
5 Select the slot number corresponding to the module by which you are connected
to the network for side B of the circuit.
6 Repeat steps 3and 4 for side B of the circuit. The following prompt appears at the
bottom of the screen:
Is the above information correct (y/n)?
7 Enter to confirm your configuration. Figure 133 shows a completed VCM VCC
y
circuit. As shown in the figure, the following message appears at the bottom of
the screen:
VC has been added.
Press any key to continue.
Figure 133 Completed VCM VCC Virtual Circuit
8 Press any key to return to the Virtual Circuit menu.
, P , A
ORTS AND PPLICATIONS