Powering The Server Off And On - Sun Microsystems Netra CT Service Manual

2
C H A P T E R

Powering the Server Off and On

This chapter gives instructions on powering the Netra CT server on and off.
Section 2.1, "Powering On the Server" on page 2-2
I
Section 2.2, "Powering Off the Server" on page 2-6
I
Note – Whenever you reboot or power your server on and off, the hot swap states
revert back to the default full hot swap state for all I/O slots. If you want basic hot
swap on an I/O slot, you must manually reset the I/O slot to basic hot swap after
rebooting or powering your server on and off.
Note – You can also power the Netra CT server on and off through the alarm card
using the poweroff and poweron commands. Refer to the Netra CT Server System
Administration Guide for more information.
2-1