Figure 10-1 Drive Bay Cover Locations - Sun Microsystems Netra CT Service Manual

H D
D 0
AB O
RT
H D
D 0
RE
SE T
AL AR
M /U
SE R
RE
AD Y
AB O
RT
ET HE
RN
ET RE
SE T
AL AR
M /U
SE R
RE
AD
Y
micr
osys
tem s
ET HE
RN
ET
CO
M
HO
T
SW
AP
HO
TS W
AP
micr
osys tem
s
CO
M
HO
T
SW
AP
HO
TS W
AP
Drive Bay Cover Locations
FIGURE 10-1
4. Loosen the captive screws that hold the drive bay cover in place.
For the Netra CT 810 server, use a No. 1 Phillips screwdriver to loosen the four
I
captive screws (two on top and two on the bottom).
For the Netra CT 410 server, use a No. 2 Phillips screwdriver to loosen the one
I
captive screw on top.
5. Remove the drive bay cover.
6. Determine which disk drive you want to remove.
7. Unlatch the disk drive handle to release it.
Push down in the direction of the arrow to release the bracket handle latch.
8. Pull the bracket handle out and swing it open.
9. Continue to pivot the disk drive bracket handle against the chassis, applying mild
pressure until the drive disconnects.
10. Slide the drive out of the chassis and place it on the electrostatic discharge mat.
Drive bay cover, Netra CT 410 server
AB O
RT
RE
SE T
AL AR
M /U
SE R
RE
AD
Y
ET HE
RN
ET
H D
D 1
micr
osys tem
s
CO
M
HO
TS W
AP
HO
T
SW
AP
Chapter 10 Removing and Replacing Cold-Swappable Subassemblies
Drive bay cover, Netra CT 810 server
10-3