Removing And Replacing The Servers; Removing A Server - Sun Microsystems Netra CT Service Manual

9
C H A P T E R
Removing and Replacing the
Servers
This chapter specifies procedures for the installation, removal, and replacement of
the Netra CT 810 server and Netra CT 410 server. The server and the midplane are
considered a single FRU.
Consult the Netra CT Server Safety and Compliance Manual for safety information prior
to performing the procedures in this chapter.
Note – Read
9.1 Servers
You can power down and remove one server without affecting the other servers in
the chassis.
Section 9.1.1, "Removing a Server" on page 9-2
I
Section 9.1.2, "Installing a Server" on page 9-9
I
Chapter 3 before performing the procedures in this chapter.
9-1