Powering Off The Netra 150 Server - Sun Microsystems Netra 150 Server Product Note

Figure 1–2 Location of the Serial Ports on the Netra 150 Server

Powering Off the Netra 150 Server

If you shut down the Netra 150 server using the Netra HTML interface (found under
System Administration:Restart and Shutdown), this does not remove power from the
Netra 150 server. To completely power off the server, the power switch located on
the back of the Netra 150 server must be used. This is the switch for the server.
Turning this switch to the off position will actually turn off the power to the server.
Note - This switch is only to be used to power off the server to allow new hardware
to be installed or replaced. Always shutdown the server gracefully before powering
off the server.
Netra 150 Server Product Note ♦ Revision A, February 1997
4