Figure 6-9 Tightening The Ejection Lever Captive Screws - Sun Microsystems Netra CT Service Manual

FIGURE 6-9
Note – If you are hot-swapping an alarm card, it may take several minutes before
the amber Okay to Remove LED goes off and the alarm card prompt comes up. Do
not proceed with these instructions until the alarm card prompt comes up.
12. Log into the Netra CT server.
Refer to
to this procedure.
13. Determine the hot swap state for the slot that holds the card you just installed.
To determine the current hot swap state for the slots in your server, as root, enter:
# prtconf -v -P
6-20 Netra CT Server Service Manual • January 2004
Tightening the Ejection Lever Captive Screws
Section 5.2.1, "Logging In to the Netra CT Server" on page 5-4, then return