Sun Microsystems Netra CT Service Manual page 143

4. Deactivate the hard disk drive.
As root, enter:
# cfgadm -c unconfigure ap_id
where ap_id is the attachment-point ID for the hard disk drive that you want to
remove. For example, to deactivate the upper hard disk drive (HDD 0), as root,
enter:
# cfgadm -c unconfigure c0::dsk/c0t0d0
5. Determine if you are trying to remove the boot drive or a normal data drive from
the system.
If you are trying to remove the boot drive, go to
I
If you are trying to remove a normal data drive, as root, enter:
I
# cfgadm -x remove_device ap_id
where ap_id is the attachment-point ID for the hard disk drive that you want to
remove. For example, for the upper hard disk drive (HDD 0), as root, enter:
# cfgadm -x remove_device c0::dsk/c0t0d0
6. Verify that the hard disk drive has been deactivated.
As root, enter:
# cfgadm -a c0
You should get feedback similar to the following:
Ap_Id
c0
c0::dsk/c0t0d0
c0::dsk/c0t6d0
Type
scsi-bus
unavailable
CD-ROM
Chapter 7 Removing and Replacing Hard Disk Drives and Removeable Media
Step 6.
Receptacle Occupant
connected configured
connected unconfigured unknown
connected configured
Condition
unknown
unknown
7-5