Sun Microsystems Netra CT Service Manual page 99

2. Log into the Netra CT server.
Refer to Section 5.2.1, "Logging In to the Netra CT Server" on page
to this procedure.
3. Perform any necessary card-specific software commands.
If you are removing an alarm card from the server, you should make a record of
I
the settings that you have for the current alarm card so that you can use them on
the replacement alarm card. Refer to the Netra CT Server System Administration
Manual for instructions on displaying the settings that you have on the current
alarm card. Make a record of those settings.
For any other card, there may be certain card-specific software commands that
I
you might have to perform before removing that hot-swappable card. Refer to the
documentation that you received with the card for any card-specific procedures
before proceeding with this procedure.
4. Determine the hot swap state for the slot that holds the card you are about to
remove.
To determine the current hot swap state for the slots in your server, as root, enter:
# prtconf -v -P
Chapter 6 Removing and Replacing Hot-Swappable Cards
5-4, then return
6-9