Connecting an ASCII Terminal to a CPU or CPU Transition Card
TABLE B-1
Server
Type
TTY A Port on Netra CT Server
Netra CT
• Rear-access model: DB-9 male on
810 server
the CPU rear transition card. See
Section A.3, "CPU Rear Transition
Card" on page
• Front-access model: DIN-8 female
Netra CT
410 server
on the CPU card. See
"CPU Card" on page
• Rear-access model: DB-9 male on
the CPU rear transition card. See
Section A.3, "CPU Rear Transition
Card" on page
Connecting an ASCII Terminal to an Alarm or Alarm Rear Transition Card
TABLE B-2
Server
Type
COM 1 Port on Netra CT Server
• Front-access model: RJ-45 on the alarm
Netra
CT 810
card. See
Section A.4, "Alarm Card, 6U
server
Single-Wide" on page
• Rear-access model: DB-9 male on the
alarm rear transition card. See
Section A.6, "Alarm Rear Transition
Card" on page
Netra
• Front-access model: RJ-45 on the alarm
CT 410
card. See
Section A.4, "Alarm Card, 6U
server
Single-Wide" on page A-14
Section A.5, "Alarm Card, 3U Double-
Wide" on page
• Rear-access model: DB-9 male on the
alarm rear transition card. See
Section A.6, "Alarm Rear Transition
Card" on page
2. Access the "Set Up Menu" of the ASCII terminal and bring up the Serial
Communications section.
B-2
Netra CT Server Service Manual • January 2004
A-10.
Section A.1,
A-2.
A-10.
A-14.
A-22.
or
A-18.
A-22.
Adapter
Cable
Not
DB-9 female-to-DB-
needed.
25 male straight-
through
Not
• Front-access model:
needed.
DIN-8 male-to-DB-
25 male
• Rear-access model:
DB-9 female-to-
DB-25 male
straight-through
Adapter
Cable
• Front-access
DB-9
model:
female-to-
RJ-45-to-
DB-25 male
DB-9 male
straight-
through
• Rear-access
model:
Not needed
• Front-access
DB-9
model:
female-to-
RJ-45-to-
DB-25 male
DB-9 male
straight-
through
• Rear-access
model:
Not needed
Serial
Port on
Adapter
Terminal
DB-25
DB-25
female-to-DB-
male
25 female
gender
changer
DB-25
DB-25
female-to-DB-
male
25 female
gender
changer
Serial
Port on
Adapter
Terminal
DB-25 female-
DB-25
to-DB-25
male
female gender
changer
DB-25 female-
DB-25
to-DB-25
male
female gender
changer
Need help?
Do you have a question about the Netra CT and is the answer not in the manual?