Replacing A Hard Disk Drive; Power Distribution Unit (Dc Models Only) - Sun Microsystems Netra CT Service Manual

11. Secure the drive bay cover over the drive bays (
You must install the drive bay cover over the drive bays to ensure proper airflow in
the system.
10.1.2

Replacing a Hard Disk Drive

1. Attach the antistatic wrist strap.
Refer to
2. Remove the drive bay cover (
3. Hold the bracket handle on the disk drive open.
4. Slide the replacement disk drive into the drive slot.
5. Gently push the drive until the locking handle engages.
6. Close the locking handle completely, using gentle downward pressure.
7. Replace the drive bay cover.
8. Complete the power on steps.
Refer to
9. If you are replacing your boot disk, reinstall the Solaris operating environment.
Refer to the Netra CT Server Installation Guide for more information.
10. If your hard disk(s) are under the control of RAID software, perform the
necessary steps to bring the disks online.
10.2 Power Distribution Unit (DC Models
Only)
This section tells you how to remove and replace a power distribution unit in a
chassis. Keep in mind that you must remove the server in front of the failed power
distribution unit in order to gain access to that power distribution unit; however,
you do not have to remove any other servers except for the one directly in front of
the failed power distribution unit. The power distribution unit connects directly into
the midplane and is located on the chassis, not the server (
10-4 Netra CT Server Service Manual • January 2004
Section 1.2, "Attaching the Antistatic Wrist Strap" on page
Section 2.1, "Powering On the Server" on page 2-2
FIGURE 10-1
).
FIGURE 10-1
).
1-2.
for more information.
).
FIGURE 10-2