Sun Microsystems Netra CT Service Manual page 152

c0::dsk/c0t6d0
I
I
# cfgadm -c configure c0::dsk/c0t6d0
If you installed a DAT drive in your server, you should get feedback similar to the
I
following:
Ap_Id
c0
c0::dsk/c0t0d0
c0::dsk/c0t6d0
c0::rmt/0
c0::rmt/0
I
7-14 Netra CT Server Service Manual • January 2004
Locate the line with the attachment point
column. Verify that the following entries appear for the DVD drive that you
just installed:
CD-ROM
If you see CD-ROM in the Type column and configured in the Occupant
column, then the DVD drive was activated. Go to
If you see unavailable instead of CD-ROM in the Type column and unconfigured
instead of configured in the Occupant column, then the DVD drive was not
activated. Enter the following command to activate the DVD drive:
Enter the
cfgadm -a c0
DVD drive was activated. You can also use the removeable media module
(RMM) LEDs on the system status panel to verify that the removeable media
drive has been activated. The Okay to Remove LED (
status panel for the removeable media drive should go OFF, indicating that
the removeable media drive has been activated. Go to
Type
scsi-bus
disk
unavailable
tape
Locate the line with the attachment point
column. Verify that the following entries appear for the DAT drive that you
just installed:
tape
If you see tape in the Type column and configured in the Occupant column,
then the DAT drive was activated. Go to
c0::dsk/c0t6d0
connected
command a second time to verify that the
Receptacle Occupant
connected
connected
connected
connected
c0::rmt/0
connected
Step 8.
listed in the Ap_Id
configured unknown
Step 8.
) on the system
Step 8.
Condition
configured unknown
configured unknown
unconfigured unknown
configured unknown
listed in the Ap_Id
configured unknown