Installing A Dvd Or Dat Drive - Sun Microsystems Netra CT Service Manual

7.2.2

Installing a DVD or DAT Drive

1. Attach the antistatic wrist strap.
Refer to
2. Insert the removeable media module into the server.
The Okay to Remove LED (
panel for the removeable media module should go ON.
3. Using a No. 2 Phillips screwdriver, tighten the screw on the removeable media
module to secure it to the server.
4. Remove the antistatic wrist strap.
5. Log in to the server and, as root, activate the replacement removeable media drive:
# cfgadm -c configure c0
6. If you installed a DAT drive into your server, enter the following command to
rebuild the device tree:
# devfsadm -i st
This command is not necessary if you installed a DVD drive into your server.
7. Verify that the removeable media drive has been activated.
As root, enter:
# cfgadm -a c0
If you installed a DVD drive in your server, you should get feedback similar to
I
the following:
Ap_Id
c0
c0::dsk/c0t0d0
c0::dsk/c0t6d0
c0::rmt/0
Section 1.2, "Attaching the Antistatic Wrist Strap" on page
Type
scsi-bus
disk
CD-ROM
unavailable
Chapter 7 Removing and Replacing Hard Disk Drives and Removeable Media
) and the Power LED (
Receptacle
connected
connected
connected
connected
1-2.
) on the system status
Occupant Condition
configured unknown
configured unknown
configured unknown
unconfigured unknown
7-13