Replacing The System Status Panel; Figure 8-3 Removing The System Status Panel (Netra Ct 410 Server) - Sun Microsystems Netra CT Service Manual

For the netra ct 810 server and netra ct 410 server
Hide thumbs Also See for Netra CT:
Table of Contents

Advertisement

FIGURE 8-3
4. Pull the system status panel away from the Netra CT server and place it on the
electrostatic discharge mat.
You may have to pull on the screws to remove the system status panel from the
server.
8.1.2

Replacing the System Status Panel

1. Attach the antistatic wrist strap.
Refer to
2. Carefully position the system status panel into place on the system.
FIGURE 8-4
and
FIGURE 8-5
server.
8-4
Netra CT Server Service Manual • January 2004
H D
D 0
A B O
R T
R E
S E T
A LA
R M
/U S
E R
R E
A D
Y
E T H
E R
N E
T
mic
ros
yste
ms
C O
M
H O
T
S W
A P
H O
TS W
A P
Removing the System Status Panel (Netra CT 410 Server)
Section 1.2, "Attaching the Antistatic Wrist Strap" on page
shows how to position the panel into place on the Netra CT 810 server
shows how to position the panel into place on the Netra CT 410
1-2.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Netra CT and is the answer not in the manual?

This manual is also suitable for:

Netra ct 810Netra ct 410

Table of Contents