Removing And Replacing Hard Disk Drives And Removeable Media - Sun Microsystems Netra CT Service Manual

7
C H A P T E R
Removing and Replacing Hard Disk
Drives and Removeable Media
Caution – If you are just powering on your Netra CT server, do not remove or
install any components in the system until you have verified that the system is
completely powered up. Refer to
page 2-5
Note – When removing a hot-swappable component, allow several seconds before
inserting it or another component in that slot. Rapidly removing and inserting any
hot-swappable component might panic or hang the system.
This chapter gives procedures for the installation, removal, and replacement of hard
disk drives and removeable media. It is organized as follows:
Section 7.1, "Hard Disk Drive" on page 7-2
I
Section 7.2, "DVD or DAT Drive (Netra CT 810 Server Only)" on page 7-9
I
Consult the Netra CT Server Safety and Compliance Manual for safety information prior
to performing the procedures in this chapter.
Note – Read
for more information.
Chapter 3 before performing the procedures in this chapter.
Section 2.1.1, "Verifying Full Power-Up" on
7-1