Lldp Med-Fast-Count; Lldp Med-Status - TP-Link T2500G-10TS Cli Reference Manual

34.8

lldp med-fast-count

Description
The lldp med-fast-count command is used to configure the number of the
LLDP-MED frames that will be sent out. When LLDP-MED fast start
mechanism is activated, multiple LLDP-MED frames will be transmitted based
on this parameter. The default value is 4. To return to the default
configuration, please use no lldp med-fast-count command.
Syntax
lldp med-fast-count
no lldp med-fast-count
Parameter
count
By default, it is 4.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin and Operator level users have access to these commands.
Example
Specify Fast Start Count as 5:
T2500G-10TS(config)# lldp med-fast-count 5
34.9

lldp med-status

Description
The lldp med-status command is used to enable the LLDP-MED feature for
the corresponding port. After the LLDP-MED feature is enabled, the port's
Admin Status will be changed to Tx&Rx. To disable the LLDP-MED feature for
the corresponding port, please use no lldp med-status command.
Syntax
lldp med-status
no lldp med-status
count
—— Configure the Fast Start Count parameter. It ranges from 1 to 10.
316