Mac Address-Table Max-Mac-Count - TP-Link T2500G-10TS Cli Reference Manual

vid
—— The corresponding VLAN ID of the MAC address. It ranges from 1 to
4094.
Command Mode
Global Configuration Mode
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Add a filtering address entry of which VLAN ID is 1 and MAC address is
00:1e:4b:04:01:5d:
T2500G-10TS(config)# mac address-table filtering 00:1e:4b:04:01:5d vid 1
20.4

mac address-table max-mac-count

Description
The mac address-table max-mac-count command is used to configure the
Port Security. To return to the default configurations, please use no mac
address-table max-mac-count command. Port Security is to protect the
switch from the malicious MAC address attack by limiting the maximum
number of the MAC addresses that can be learned on the port. The port with
Port Security feature enabled will learned the MAC address dynamically.
When the learned MAC address number reaches the maximum, the port will
stop learning. Therefore, the other devices with the MAC address unlearned
can not access to the network via this port.
Syntax
mac address-table max-mac-count { [ max-number
static | permanent } ] [ status { forward | drop | disable } ] }
no mac address-table max-mac-count [ max-number | mode | status ]
Parameter
num
the port. It ranges from 0 to 64. By default this value is 64.
dynamic | static | permanent —— Learn mode for MAC addresses. There are
three modes, including Dynamic mode, Static mode and Permanent mode.
When Dynamic mode is selected, the learned MAC address will be deleted
automatically after the aging time. When Static mode is selected, the learned
MAC address will be out of the influence of the aging time and can only be
—— The maximum number of MAC addresses that can be learned on
147
num
] [ mode { dynamic |