Ip Arp Inspection(Interface) - TP-Link T2500G-10TS Cli Reference Manual

Syntax
ip arp inspection trust
no ip arp inspection trust
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
Example
Configure the Gigabit Ethernet ports 1/0/2-5 as the Trusted Port:
T2500G-10TS(config)#interface range gigabitEthernet 1/0/2-5
T2500G-10TS(config-if-range)#ip arp inspection trust
14.3

ip arp inspection(interface)

Description
The ip arp inspection command is used to enable the ARP Defend function.
To disable the ARP detection function, please use no ip arp inspection
command. ARP Attack flood produces lots of ARP Packets, which will occupy
the bandwidth and slow the network speed extremely. With the ARP Defend
enabled, the switch can terminate receiving the ARP packets for 300 seconds
when the transmission speed of the legal ARP packet on the port exceeds the
defined value so as to avoid ARP Attack flood.
Syntax
ip arp inspection
no ip arp inspection
Command Mode
Interface Configuration Mode (interface gigabitEthernet / interface range
gigabitEthernet)
Privilege Requirement
Only Admin, Operator and Power User level users have access to these
commands.
106