Instructions
Example
Purpose
Command Modes
Syntax
local-label
<local-label>
remote-label
<remote-label>
This command is supported after the platform version 4.6.02.
This example describes how to show the current L2 transport bind-
ing information.
ZXR10(config)#show mpls l2transport binding
Destination Address: 3.4.5.6,
Local Label:
16
Cbit: 0
MTU: 1500
Remote Label: 16
Cbit: 0
MTU: 1500
Destination Address: 3.4.5.6,
Local Label:
17
Cbit: 0
MTU: 1500
Remote Label: 17
Cbit: 0
MTU: 1500
The displayed field descriptions are shown below.
Field
Destination Address
VC ID
Local Label
Cbit
VC Type
GroupID
MTU
Interface Desc
Remote Label
show mpls l2transport vc
Use this command to check the VC information transmitted at
Layer 2.
All modes
show mpls l2transport vc [{vcid <vcidmin>[<vcidmax>]|
interface <interface-name>[<loca-lcircuit-id1>[<local-circuit-id
2>]]| destination <ip-addr>}][detail]
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
Locally assigned label, range: 0~1048575
Remotely assigned label, range: 0~1048575
VC ID: 201
VC Type: VLAN
Interface Desc: fei_1/2.1
VC Type: VLAN
Interface Desc: fei_5/5.1
VC ID: 202
VC Type: VLAN
Interface Desc: fei_1/2.2
VC Type: VLAN
Interface Desc: fei_5/5.2
Description
Peer address
ID of VC
Locally assigned label
Flag of control field
Type of VC
Group ID information
Maximum transmission unit
Port information
Remotely assigned label
GroupID: 0
GroupID: 0
GroupID: 0
GroupID: 0
33