Show Mpls Label Range - Zte ZXR10 8900 Series Command Reference Manual

Output interface: fei_1/1 ,imposed label stack { 16 }
Create time: 10:42:39, last status change time: 10:42:39
Signalling protocol: LDP, peer 3.4.5.6:0 up
MPLS VC labels: local 16, remote 16
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:fei_5/5.1
Sequencing: receive disabled, send disabled
The displayed field descriptions are shown below.
Field
LocalIntf(LocalInter-
face)
LocalCircuit
DestAddress
VCID
Status
Tunnel label
Output interface
imposed label stack
Create time
last status change
time
Signalling protocol
MPLS VC labels
Group ID
MTU
Remote interface
description
Sequencing

show mpls label range

Purpose
Use this command to show the label range that LDP can use.
Description
Local interface bounded with VPWS
Link ID of local interface. It is displayed
as ETHER; VlanID for the interface
encapsulated with Ethernet; AAL5 vpi/vci
for the ATM interface encapsulated with
AAL5; DCLI for the interface encapsulated
with FR; or PPP for the interface
encapsulated with ppp
VC destination address (global next hop
address)
Designated VCID
VC current state: VC is up only when local
interface is up and resolves valid outer
tunnel label
Outer tunnel label, displayed as direct
connection or RSVP-TE
Actual output interface
Label stack in the packet
Time when VC is created
Period since VC changed recently
Signalling protocol for allocating VC labels
VC label
Group identifier
Maximum transmission unit
Description of the remote interface
bounded with VPWS
Sequencing function
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
35