Mtu; Peer - Zte ZXR10 8900 Series Command Reference Manual

Instructions
Example
Related Command
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Use this command to configure VPLS layer 2 control message for-
warding policy.
This example applies layer 2 control message forwarding policy in
a vfi on PE to configure all kinds of message transparent transmis-
sion.
ZXR10(config-vfi)# l2protocol-tunnel all
show vfi

mtu

Use this command to configure mtu attribute of VFI.
VFI configuration mode
mtu <mtu-value>
no mtu
<mtu value>
This command is supported after the platform version 4.8.23.
When establishing PW between two PE's, two side need to negoti-
ate mtu value of pw. In case mtu values on two sides are different,
pw will fail to be established.
Mtu of VFI can be configured before VFI is associated with interface
or configured with peer, or mtu configuration of VFI will fail to be
modified.
Configure mtu on PE VFI mode:
ZXR10(config)#vfi vfi1
ZXR10(config-vfi)#mtu 1452
vfi
vcid

peer

peer

Use this command to specify the addresses of other PEs in the
same VPLS domain and establish pseudo-wires. Delete the estab-
lished pseudo-wires with the no form of this command.
Use this command to configure a pair of addresses of other PEs
and the vcid in a static multi-hop pseudo-wire S-PE instance, and
establish pseudo-wires. Delete the established pseudo-wires with
the no form of this command.
VFI configuration and CFI MSPW configuration
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 VPLS Configuration
The size of mtu, range:12816383
61