Show Mpls Traffic-Eng Tunnels Remote-Tunnel - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Purpose
Command Modes
Syntax
Syntax
Description
Example
102 Confidential and Proprietary Information of ZTE CORPORATION
Field
InLabel
OutLabel
src
Dst
Tun_Id
Tun_Instance
Explicit Route
Record Route
show mpls traffic-eng tunnels
remote-tunnel
Use this command to show remote MPLS tunnel in detail.
All modes except user EXEC
show mpls traffic-eng tunnels remote-tunnel [tunnel-id<tu
nnel_id> lsp-id<lsp_id> ingress-id <ingress_id> egress-id<eg
ress_id>]
tunnel-id<tunnel_
id>
lsp-id<lsp_id>
ingress-id
<ingress_id>
egress-id<egress_
id>
This example describes how to show information about the re-
mote tunnel. The ingress address is 1.1.1.15, the egress address
is1.1.1.25, the tunnel identifier is 2, and the instance identifier is
6.
ZXR10#show mpls traffic-eng tunnels remote-tunnel
tunnel-id 2 lsp-id 6 ingress-id 1.1.1.15 egress-id 1.1.1.25
LSP Tunnel tunnel_2 is signaled, connection is up
InLabel:fei_1/1, 0
OutLabel:-
RSVP Signalling Info :
src 1.1.1.15 , Dst 1.1.1.25, Tun_Id 2, Tun_Instance 6
RSVP Path Info:
Explicit Route: 80.1.2.2 1.1.1.25
Record Route: NONE
Tspec:ave rate= 0 kbits, burst= 2000 bytes,
peak rate = 0 kbits
RSVP Resv Info:
Record Route: NONE
Description
Incoming label and the interface of the tunnel
Outgoing label and the interface of the tunnel
Source address of the tunnel
Destination address of the tunnel
Tunnel identifier
LSP identifier of the tunnel
Explicit path established in the tunnel
Address of each hop of the tunnel
Tunnel identifier of the remote tunnel
Instance identifier of the remote tunnel
Ingress address of the remote tunnel
Egress address of the remote tunnel