Tunnel Mpls Traffic-Eng Autoroute Announce; Tunnel Mpls Traffic-Eng Autoroute Metric - Zte ZXR10 8900 Series Command Reference Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Fspec:ave rate= 0 kbits, burst= 2000 bytes,
peak rate = 0 kbits
The descriptions of the displayed information are shown below.
Field
InLabel
OutLabel
src
Dst
Tun_Id
Tun_Instance
Explicit Route
Record Route
tunnel mpls traffic-eng
autoroute announce
Use this command to enable MPLS automatic routing on the tunnel
interface. Disable this function with the no form of this command.
Tunnel interface configuration

tunnel mpls traffic-eng autoroute announce

no tunnel mpls traffic-eng autoroute announce
The tunnel does not support automatic routing by default.
This command is supported after the platform version 4.8.20.
This example describes how to enable MPLS automatic routing on
the tunnel interface.
ZXR10(config)#interface tunnel5
ZXR10(config-if)#tunnel mpls traffic-eng autoroute announce
tunnel mpls traffic-eng
autoroute metric
Use this command to configure the metric type and value of the
tunnel automatic route. Disable this function with the no form of
this command.
Tunnel interface configuration
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
Description
Ingress labels and the interface of the tunnel
Egress labels and the interface of the tunnel
Source address of tunnel
Destination address of tunnel
Tunnel identifier
LSP identifier of the tunnel
Explicit path established by the tunnel
Address of each hop of the tunnel
103