Show Mpls Traffic-Eng Tunnels - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (MPLS)
Command format
Parameter
Description
Default
Configuration
Tips
Purpose
Command Modes
Syntax
Syntax
Description
Example
100 Confidential and Proprietary Information of ZTE CORPORATION
show mpls traffic-eng interface packet-counter [<interface-
name>]
Parameter
<interface-name>
This command shows the detailed information about the number
of packets on the interface configured with RSVP TE function.
V4.08.21 and its later versions support this command.

show mpls traffic-eng tunnels

Use this command to show detailed information about the MPLS
tunnel.
All modes except user EXEC
show mpls traffic-eng tunnels [brief][summary][tunnel
<tunnel_id>]
brief
tunnel <tunnel_id>
summary
This example shows brief information (the data below is for refer-
ence only).
ZXR10#show mpls traffic-eng tunnels brief
Signalling Summary:
LSP Tunnels Process: running
RSVP Process: running
Forwarding: enabled
TUNNEL NAME DESTINATION UP IF
Tunnel_1 10.112.0.12 -
Tunnel_2 10.110.0.10 -
Tunnel_3 10.110.0.20 fei_1/2fei_1/4 up/up
The descriptions of the displayed information are shown below.
Field
LSP Tunnels Process
RSVP Process
Forwarding
TUNNEL NAME
DESTINATION
UP IF
Description
This is a locally configured interface with
RSVP TE function.
Shows brief tunnel information
Shows local tunnel information
Shows statistic tunnel information
DOWN IF STATE/PROT
unknown up/down
fei_1/4 up/up
Description
LSP tunnel state
RSVP protocol state
Forwarding state
Tunnel name
Destination address of the tunnel
Uplink interface of the tunnel