Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
loose
<A.B.C.D>
There is no explicit path by default.
Use this command to configure an explicit path and specify the
next hop information for the traffic engineering tunnel. The path
can be identified by a name or a digit, and its next hops are ranked
with the sequence configured.
This example describes how to configure a explict path named test.
The next hop is a loose path 100.1.1.1.
ZXR10(config)#ip explicit-path name test next-address 100.1.1.1 loose
ip rsvp authentication
Use this command to enable RSVP authentication on the interface.
Cancel this configuration with the no form of this command.
Interface configuration
ip rsvp authentication
no ip rsvp authentication
There is no RSVP authentication on the interface by default.
�
This command is a must. This command must be configured
on the interface for enabling RSVP authentication.
�
This command is supported after the platform version 4.8.21.
This example describes how to enable RSVP authentication on the
interface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rsvp authentication
ip rsvp authentication
challenge
Use this command to enable challenge mechanism on the inter-
face of local device. The interface as a receiver requires challenge
mechanism be used to confirm the first sequence. If the neigh-
bor fails to pass the challenge, neighbor packets are not received.
Disable this function with the no form of this command.
Interface configuration
ip rsvp authentication challenge
no ip rsvp authentication challenge
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
Loose path
IP address of the neighbor node, in the dotted
decimal notation
79