Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
�
This example describes how to reset dampening information of
a LSP.
ZXR10#clear mpls ldp dampening
clear mpls ldp flap
Use this command to clear the flapping statistic information of LDP
routers.
Privileged EXEC
clear mpls ldp flap [<ip-address><net-mask>]
<ip-address>
<net-mask>
After this command is configured, the router will clear the count of
the flapping of LDP entities where flapping has already occurred ,
and the router will reset the count of the flapping of some specified
LSP; only the count of the flapping of this LSP is cleared and reset
and it will be recounted from 0.
�
This example describes how to rest LDP flapping statistic infor-
mation.
ZXR10#clear mpls ldp flap
�
This example describes how to reset the flapping statistic in-
formation of a LSP.
ZXR10#clear mpls ldp flap 100.1.1.1 32
mpls ip (Global
Configuration)
Use this command to enable LDP to establish an LSP along a com-
mon hop-by-hop routing path. Disable LDP with the no form of
this command.
Global configuration
mpls ip
no mpls ip
LDP is disabled by default.
�
his command enables LDP to establish an LSP along a common
hop-by-hop routing path. In addition, it is necessary to enable
LDP on the interface to realize dynamic label switching on the
interface.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
Network IP address, in the dotted decimal
format
Network mask, in the dotted decimal format
11