Tunnel Mpls Traffic-Eng Path-Option - Zte ZXR10 8900 Series Command Reference Manual

Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
If the interface is used by an UP tunnel, the configuration of this
command is invalid. In this case, shut down the UP tunnel first.
This example describes how to configure the reserved bandwidth
as 100kbps.
ZXR10(config)#interface fei_3/1
ZXR10(config-if)#tunnel mpls traffic-eng bandwidth 100
tunnel mpls traffic-eng
path-option
Use this command to configure to obtain ERO by dynamic selection
or explicit path statically on tunnel interface of the device. Cancel
the setting with the no command.
Tunnel interface configuration
tunnel mpls traffic-eng path-option <number>{dynamic |
explicit {name <path-name>| identifier <id>}}
no tunnel mpls traffic-eng path-option <number>
<number>
name <path-name>
dynamic
identifier <id>
There is no path option configured for the tunnel.
The establishment of the traffic engineering tunnel provides path
constraints to designate a flag for each optional path.
This example describes how to configure the method of obtaining
ERO is dynamic selection.
ZXR10(config)#interface tunnel5
ZXR10(config-if)#tunnel mpls traffic-eng path-option 1 dynamic
The following contents will be shown after using this command.
ZXR10#show mpls traffic-eng tunnels summary
Signalling Summary:
LSP Tunnels Process:
RSVP Process:
Forwarding:
Head:6 interfaces,2 active signalling attempts,2 established
Midpoints:0,Tails: 64
The descriptions of the displayed information are shown below.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 5 MPLS Traffic Engineering Configuration
Number of the option, range: 1~16
Name of the used explicit path, 1~16
characters
Uses the dynamic path computation mode
Digital identifier of the used explicit path,
range: 1~65535
running
run
enabled
105