Tunnel Sequence; Tunnel Source - Zte ZXR10 8900 Series Command Reference Manual

Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Purpose
Command Modes
Syntax
Syntax
Description
Example
History Command
gre ip
mpls traffic-eng
ipv6ip
ipv6ip 6to4
ipipv6
ZXR10 5900 series support 6in4 and 6to4 tunnels only. The other
types of routers and switches supports all of kinds of tunnels.
This example describes how to configure the tunnel as GRE tunnel.
ZXR10(config)#interface fei_7/1
ZXR10(config-if)#tunnel mode gre ip

tunnel sequence

Use this command to configure local GRE tunnel to enable the tun-
nel sequence option. Cancel the configuration with the no form of
this command.
Interface configuration

tunnel sequence

no tunnel sequence

tunnel source

Use this command to configure the source address for the tunnel.
Cancel the configuration with the no form of this command.
Interface configuration
tunnel source {ipv4 | ipv6}<ip-address>
no tunnel source
<ip-address>
This example describes how to set the source address of the tunnel
as 10.10.10.1.
ZXR10(config)#interface fei_2/1 ZXR10(config-if)#tunnel
source ipv4 10.10.10.1
tunnel source <ip-address>
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 3 MPLS BGP VPN Configuration
Configures the tunnel as GRE tunnel
Configures the tunnel as mpls traffic engine
tunnel
Configures the tunnel as ipv6 over ip tunnel
(provided only in the project supporting IPv6)
Configures the tunnel as 6to4 tunnel
(provided only in the project supporting IPv6)
Configures the tunnel as 4in6 tunnel (provided
only in the project supporting IPv6)
Source IP address or IPv6 address of the
tunnel
57