Syntax
Description
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
holdtime <holdtime>
interval <interval>
This example describes how to set the status holdtime as 100 sec-
onds and the interval for sending hello messages as 20 seconds.
ZXR10(config)#mpls ldp discovery hello holdtime 100
ZXR10(config)#mpls ldp discovery hello interval 20
show mpls ldp parameter
mpls ldp discovery
targeted-hello
Use this command to configure the interval for sending LDP hello
discovery messages and the timeout time of the discovered LDP
neighbor between the indirectly connected LSRs. To restore de-
fault, use the no form of this command.
Global configuration
mpls ldp discovery targeted-hello {holdtime <holdtime>|
interval <interval>}
no mpls ldp discovery targeted-hello {holdtime | interval}
holdtime <holdtime>
interval <interval>
This command is supported after the platform version 4.6.02.
This example describes how to set the status holdtime as 100 sec-
onds and the interval for sending hello messages as 20 seconds.
ZXR10(config)#mpls ldp discovery targeted-hello holdtime 100
ZXR10(config)#mpls ldp discovery targeted-hello interval 20
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
Holdtime (in seconds) of the status if the
neighbor discovered by LDP can not receive
any subsequent hello messages, range:
1~2147483, default: 15 seconds
Interval of LDP's periodically sending hello
messages (in seconds), range: 1~2147483,
default: 5 seconds
Holdtime of the status if the neighbor
discovered by LDP can not receive any
subsequent hello messages (in seconds),
range: 1~2147483, default: 45 seconds
Interval of LDP's periodically sending hello
messages (in seconds), range: 1~2147483,
default: 15 seconds
21