Purpose
Command Modes
Syntax
Example
show mpls ldp parameters
Use this command to show information about current parameters
of LDP.
User EXEC and privileged EXEC
show mpls ldp parameters
This example describes how to show the current parameter infor-
mation about LDP.
ZXR10#show mpls ldp parameters Protocol version: 1
Downstream label pool: min label: 16; max label: 100000 Session
hold time: 180 sec; keep alive interval: 60 sec Discovery
hello: holdtime: 15 sec; interval: 5 sec Downstream on
Demand max hop count: 255 LDP initial/maximum backoff: 15/120
sec LDP loop detection: off
The displayed field descriptions are shown below.
Field
Protocol version
Downstream label
pool
Session hold time
keep alive interval
Discovery hello
Downstream on
Demand max hop
count
LDP initial/maximum
backoff
LDP loop detection
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 MPLS LDP Configuration
Description
Version
Label pool information
Holdtime of the session
Interval for sending keepalive messages
Setting of basic discovery parameters
Reserved version upgrading
Setting of parameters for the LDP session
backoff reestablishment mechanism
Reserved version upgrading
45